Comments on: Oil & Gas Construction Diver & What They ‘Do’ Offshore

By: Reza Dashmir

Reza Dashmir — Sat, 17 Jan 2009 05:03:17 +0000

Dear Azwan,
Thank you for your E-mail(have you done the metrology before?),
No,I donot have any expreince about metrology,but I like Learn.
I joined to 4 pipe line project,as a diver&during that had stinger inspection,tuch down point cheack,install PLEM,recovery wet buckle,lunching 2 jacket…,
could you learn me,if you have any metrology expreince,please.
I look forward to hearing from you.
Best Regard.
Reza Dashmir

By: fe.azwan

fe.azwan — Fri, 16 Jan 2009 18:11:20 +0000

Reza,

Have you done the metrology before?

By: Reza Dashmir

Reza Dashmir — Thu, 15 Jan 2009 04:36:08 +0000

Dear Sabur,
Thank You for Your e-mail,I like konw is there any Web-site or on line Article,that is discrib completly jig mesurment.
Please direct me.
I look forward to hearing from You.
Best Regard.
Reza Dashmir

By: Sulaiman Sabur

Sulaiman Sabur — Wed, 14 Jan 2009 13:35:55 +0000

There are different kind of Diver Metrology Jig and procedures of getting the measurement also different depend on the work requirement, distance, visibility, jig design and so on… But one of the rule of thumb for diver measurement is always have a reference point. It is important to check your measurement accuracy.

By: Reza Dashmir

Reza Dashmir — Sat, 10 Jan 2009 05:15:42 +0000

Dear Sir,
Thank You for your good web site&usefull information in that.

may I ask you for full information about flang to riser metrology by diver by jik,please.
I look forward to hearing from you.
Best Regard.
Reza Dashmir